i have a question about the following at command: AT+RFPOWER=<tx_power_level>.
i have seen that the command works changing tx power level because the radio replies with a "OK".
but...what happens if i turn off the power supply and i reconnect it again? can the module maintain that value or not?
I have seen the same behavior as Alessandro. I would also like to know if the new RXPOWER is saved. I have the Esp8266_at_instruction_set_en_v1.5.4_0.pdf instruction set. Based on the pattern of how the commands are documented, I'm guessing the value is not saved. Can someone confirm, please?
Who is online
Users browsing this forum: No registered users and 5 guests
Newbies Start Here
Are you new to ESP8266?
Unsure what to do?
Dunno where to start?
Start right here!
We also have a RTOS version and a MESH version too!
Complete listing of the official ESP8266 related documentation release by ESPRESSIF!
Must read here!