Certification test mode does not work

umahashi
Posts: 1
Joined: Tue Nov 29, 2016 7:50 pm

Certification test mode does not work

Postby umahashi » Tue Nov 29, 2016 8:14 pm

Now I'm using this certification test mode on ESP-WROOM-02.
viewtopic.php?f=57&t=1341&p=4459

I think the downloading was succeeded because ESP-WROOM-02 boots.
But anything command is not accepted. It shows "cmd not exist!" or "cmd syntax error!".
I can't enter the certification test mode.

Code: Select all

DEFAULT_TEST.BIN
BK:5,3,4,2,
phy: 918, 20160401
cmd not exist!
 cmd syntax error!
 cmd syntax error!
 cmd syntax error!

ESP_Xutao
Posts: 134
Joined: Tue Sep 27, 2016 5:42 pm

Re: Certification test mode does not work

Postby ESP_Xutao » Mon Dec 05, 2016 5:20 pm

Hi:
Your download config is wrong,in "ESP8266-DOWNLOAD TOOL",you should select correct "SPI MODE"about your flash type.If you select "QIO",you can select DOUT mode.

ESP_Greg
Posts: 49
Joined: Thu Sep 17, 2015 6:10 pm

Re: Certification test mode does not work

Postby ESP_Greg » Thu Dec 08, 2016 3:33 pm

Hi,
It's the uart command format issue. Please don't use new line mode when you send the command.

petrotek
Posts: 1
Joined: Fri Jan 20, 2017 8:45 pm

Re: Certification test mode does not work

Postby petrotek » Fri Jan 20, 2017 9:49 pm

I am facing the same problem.How can i solve this problem.Can anyone suggest me the best way to solve these problem?

Who is online

Users browsing this forum: No registered users and 2 guests