esp8266-01 vs esp8266-12F deep sleep

randobi99
Posts: 1
Joined: Sat Jan 28, 2017 8:18 am

esp8266-01 vs esp8266-12F deep sleep

Postby randobi99 » Sun Jan 29, 2017 3:41 am

I have a program running on a version -01 (8 pin header) that consumes <1mA in deep sleep but the -12F version consumes ~35mA running the same program, both programmed with Arduino IDE, and no LEDs are on.
Any ideas why that is the case?

User avatar
pratik
Posts: 450
Joined: Wed Jun 29, 2016 7:17 pm
Location: India
Contact:

Re: esp8266-01 vs esp8266-12F deep sleep

Postby pratik » Sun Feb 12, 2017 1:42 pm

The only difference between these is the flash chip used. Apart from that, it will also matter what stuff is connected to the ESP8266 GPIOs. ESP-01 has very few IOs available so you cannot load down the pins and draw current.
But in ESP-12 you can connect low impedance loads and increase current sink/source on the pins. So make sure your loads are sleeping/high impedance.
Regards,
Pratik Panda
Website: http://www.PratikPanda.com

Custom firmware, Knowledge base and freelancing (ESP8266/ESP32):
http://www.iot-bits.com

Who is online

Users browsing this forum: No registered users and 2 guests