Which send command are you using?
Did you try AT+CIPSENDBUF command to send multiple blocks one after the other?
Suppose I can break the data into multiple packet of 2048 or less bytes, I send the first one: AT+CIPSEND=chn id, 2048, check OK and then 2048 bytes data and wait for SEND OK, and then repeat the process until all packet is gone and then send (AT+CIPCLOSE) to close the channel?
How about 20ms interval in between, it can be reasily over 20ms if I have to wait for the response.
thanks for any responses.
Who is online
Users browsing this forum: No registered users and 2 guests
Newbies Start Here
Are you new to ESP8266?
Unsure what to do?
Dunno where to start?
Start right here!
We also have a RTOS version and a MESH version too!
Complete listing of the official ESP8266 related documentation release by ESPRESSIF!
Must read here!