Does a WROOM-02 come with factory firmware that makes that possible?
Espressif fan and developer of flame boss smoker controller
If you need a specific default program with a very large number of WROOM-02 module, I'm sure we can arrange for your requirements.
Usually, the fastest way of producing programmed modules is by programming the flash chip directly before it is put into the WROOM-02 PCB. OTA programming on fresh modules will not be convenient on the production line because once the module is produced, you will need UART interface to initiate and verify the firmware/hardware anyway. I'd recommend having a PCB edge connector for programming the boards after production. Fastest feasible way I guess?
BTW, FlameBoss is pretty cool!
Who is online
Users browsing this forum: No registered users and 5 guests
Newbies Start Here
Are you new to ESP8266?
Unsure what to do?
Dunno where to start?
Start right here!
We also have a RTOS version and a MESH version too!
Complete listing of the official ESP8266 related documentation release by ESPRESSIF!
Must read here!