We are interfacing modem (SIM800) with UART0 of ESP-12F. We are getting Rx Overflow in UART Driver when 656 bytes are received from modem. We are trying to solve proble with RTS/CTS and made following connection as RTS/CTS line in UART Driver are GPIO15 and GPIO13
GPIO15 (RTS) ---------------------Modem (CTS)
GPIO13 (CTS) ---------------------Modem (RTS)
If we remove Pull down from GPIO15 then ESP does not boot that is the reason for having 10K->GND on GPIO15
When we tried with this connection setup, AT command does not reach to modem (we have verified that hardware flow control is enabled in modem, also enabled in ESP - uart.h)
How to use RTS/CTS on UART0 with ESP8266 ? Why it is not working?
Who is online
Users browsing this forum: No registered users and 8 guests
Newbies Start Here
Are you new to ESP8266?
Unsure what to do?
Dunno where to start?
Start right here!
We also have a RTOS version and a MESH version too!
Complete listing of the official ESP8266 related documentation release by ESPRESSIF!
Must read here!