ESP8266 Developer Zone The Official ESP8266 Forum 2017-12-07T09:03:05+08:00 https://bbs.espressif.com:443/feed.php?f=16&t=2805 2017-12-07T09:03:05+08:00 2017-12-07T09:03:05+08:00 https://bbs.espressif.com:443/viewtopic.php?t=2805&p=18582#p18582 <![CDATA[Re: question about "AT+RFPOWER" command]]>
I have seen the same behavior as Alessandro. I would also like to know if the new RXPOWER is saved. I have the Esp8266_at_instruction_set_en_v1.5.4_0.pdf instruction set. Based on the pattern of how the commands are documented, I'm guessing the value is not saved. Can someone confirm, please?

Thanks!
Joe

Statistics: Posted by Joe WeatherBalloon — Thu Dec 07, 2017 9:03 am

]]> 2016-09-22T23:59:20+08:00 2016-09-22T23:59:20+08:00 https://bbs.espressif.com:443/viewtopic.php?t=2805&p=9924#p9924 <![CDATA[question about "AT+RFPOWER" command]]>
i have a question about the following at command: AT+RFPOWER=<tx_power_level>.
i have seen that the command works changing tx power level because the radio replies with a "OK".
but...what happens if i turn off the power supply and i reconnect it again? can the module maintain that value or not?

Thanks,

Alessandro

Statistics: Posted by Alessandro Cortese — Thu Sep 22, 2016 11:59 pm

]]>