Cannot flash nodemcu after enabling internal pull up resistors on pin 2,3,4..,7

2018-07-10T01:20:29+08:00

After I set up pins 2,3,4,5,6,7 as INPUT_PULLUP my serial monitor went crazy and I'm not able to flash my board, I'm aware that D3, D4 are important for flashing, but I accidentally did it, is there any way to pull down those internal pull up, or reset/reflash my board.

Statistics: Posted by ABC_anon — Tue Jul 10, 2018 1:20 am

ESP8266 Developer Zone

Cannot flash nodemcu after enabling internal pull up resistors on pin 2,3,4..,7