ESP8266 Developer Zone

Re: L1 & L2

2016-02-03T10:57:21+08:00

Hi SpenZerX，

If it is for mass production, we recommend you to pre-burn flash IC(off-line mode) and then solder it onto module.

Any more questions, please let us know.

Thanks.

Statistics: Posted by Espressif_Kelly — Wed Feb 03, 2016 10:57 am

Re: L1 & L2

2016-01-11T18:36:34+08:00

OK, thanks,

an other question:

do you think in circuit flashing is possible? I have an clamp that fits. Any chance?

What is the recommended way to flash the chip in series production? Serial flash by com terminal and your tool or assembling of preflashed chips? Or will the heat from reflow soldering erase the flash?

The problem is that my product is very small. Serial Com terminals are pcb-vias only.

Statistics: Posted by SpenZerX — Mon Jan 11, 2016 6:36 pm

Re: L1 & L2

2016-01-07T20:07:46+08:00

Dear SpenZerX,

If you need to do antenna impedence matching, please contact feedback@espressif.com and send two pcs of your module with antenna to us for testing.

Thanks.

Statistics: Posted by Espressif_Kelly — Thu Jan 07, 2016 8:07 pm

Re: L1 & L2

2016-01-06T18:54:25+08:00

Hi,

my prototype using this design has good RF-Range. Should i worry about L1 & L2? (I used componets inspired by ESP-07 design)

Is there any service from espressif to check and optimize ESP8266 SOC integration in new hardware projects?

SpenZerX

Statistics: Posted by SpenZerX — Wed Jan 06, 2016 6:54 pm

Re: L1 & L2

2016-01-06T16:09:17+08:00

Dear SpenZerX,

I am afraid we can not directly give the recommended value of L1 and L2 to you without test. Because values of π-type network depends on the external antenna and impedance control of your board.

Thanks.

Statistics: Posted by Espressif_Kelly — Wed Jan 06, 2016 4:09 pm

L1 & L2

2016-01-05T16:54:17+08:00

Hello Espressif,

can you give me an recommendation for components
L1
L2
on my prototype?

Thank you

Statistics: Posted by SpenZerX — Tue Jan 05, 2016 4:54 pm