ESP8266 Developer Zone

Re: 又没有关于boot mode的说明

2015-06-09T12:39:54+08:00

Hi YimingLi,
Thanks for demystifying it.
Baoshi

Statistics: Posted by baoshi — Tue Jun 09, 2015 12:39 pm

Re: 又没有关于boot mode的说明

2015-06-09T11:14:00+08:00

Hi baosi,

Please check this document 0D a little further, just below the MTDO/GPIO0/GPIO2 for boot_sel[2:0], to find that there is also a list of SDIO boot sel[2:0] by SD_D3/SD_D2/SD_D0, which give valus to the y here.

Meanwhile, it should be easy for you to make experiemnts to confirmation your guess if any. I recomend you to do your own experiment to valid it. I am not a guy from espressif.

Any further question feel free to raise.

Statistics: Posted by Guest — Tue Jun 09, 2015 11:14 am

Re: 又没有关于boot mode的说明

2015-06-09T10:25:58+08:00

Yes this is as close as I can get.

So boot mode (x, y)
x is 0-7 according to Strapping page/
What is y?

Thanks

Statistics: Posted by baoshi — Tue Jun 09, 2015 10:25 am

Re: 又没有关于boot mode的说明

2015-06-08T22:32:54+08:00

reset cause 1: normally during a Power-On-Reset or by CHIP_PD transient
reset cause 2: normally during a reset caused by a nRESET transient
reset cause 4: normally during a reset by wdt reset

Statistics: Posted by Guest — Mon Jun 08, 2015 10:32 pm

Re: 又没有关于boot mode的说明

2015-06-08T22:14:53+08:00

Hi baosi,

You may please check the document 0D-ESP8266__Pin_List__Release_15-11-2014.xlsx http://bbs.espressif.com/download/file.php?id=442

Statistics: Posted by Guest — Mon Jun 08, 2015 10:14 pm

又没有关于boot mode的说明

2015-06-08T21:37:38+08:00

ESP8266在reset的时候可以从UART0收到类似
ets Jan 8 2013,rst cause:2, boot mode:(3,6)
的信息。
能不能官方说明一下，rst cause, boot mode的各个数字是什么意思。
比如我看过
boot mode:(3,6) (3,7) 是flash boot
boot mode: (1,6) (1, 7) 是 UART download
还有一些奇怪的数字比如(3,0)就不知道怎么回事了
谢谢

Statistics: Posted by baoshi — Mon Jun 08, 2015 9:37 pm