ESP8266 Developer Zone The Official ESP8266 Forum 2018-07-16T15:39:51+08:00 https://bbs.espressif.com:443/feed.php?f=65&t=10362 2018-07-16T15:39:51+08:00 2018-07-16T15:39:51+08:00 https://bbs.espressif.com:443/viewtopic.php?t=10362&p=22101#p22101 <![CDATA[Re: ESP8266 crash]]>
I suspect that the ESP is running some other software, not the 'standard' AT command firmware,
because on power-up it creates a WiFi AP without being told to do so...

Statistics: Posted by radders — Mon Jul 16, 2018 3:39 pm

]]> 2018-07-11T17:57:14+08:00 2018-07-11T17:57:14+08:00 https://bbs.espressif.com:443/viewtopic.php?t=10362&p=22055#p22055 <![CDATA[Re: ESP8266 crash]]> Statistics: Posted by Her Mary — Wed Jul 11, 2018 5:57 pm

]]> 2018-06-26T16:36:41+08:00 2018-06-26T16:36:41+08:00 https://bbs.espressif.com:443/viewtopic.php?t=10362&p=20916#p20916 <![CDATA[ESP8266 crash]]>
I have an ESP8266 connected to a terminal program on my PC.

The only message I see is this:

Code:

 ets Jan 8 2013,rst cause:2, boot mode:(3,6)

load 0x40100000, len 25700, room 16
tail 4
chksum 0x0b
load 0x3ffe8000, len 848, room 4
tail 12
chksum 0x3f
ho 0 tail 12 room 4
load 0x3ffe8350, len 184, room 12
tail 12
chksum 0xb7
csum 0xb7


This is transmitted at a baud rate of 74880. No other communication is possible.

What is causing this? I haven't written anything to the chip - it is as supplied to me.

Statistics: Posted by radders — Tue Jun 26, 2018 4:36 pm

]]>