ESP8266 Developer Zone The Official ESP8266 Forum 2016-04-19T05:29:46+08:00 https://bbs.espressif.com:443/feed.php?f=7&t=2047 2016-04-19T05:29:46+08:00 2016-04-19T05:29:46+08:00 https://bbs.espressif.com:443/viewtopic.php?t=2047&p=6521#p6521 <![CDATA[Re: Problem connecting to TP-Link TL-WR841ND v8 using DD-WRT]]> Quite strange behaviour?

Good signal quality and signal to noice ratio according to DD-WRT. Link is at 2/1Mbit. Some kind of powersave?

Best regards
Mikael

Statistics: Posted by adent — Tue Apr 19, 2016 5:29 am

]]> 2016-04-18T08:00:55+08:00 2016-04-18T08:00:55+08:00 https://bbs.espressif.com:443/viewtopic.php?t=2047&p=6501#p6501 <![CDATA[Problem connecting to TP-Link TL-WR841ND v8 using DD-WRT]]>
Router is TP-Link TL-WR841ND v8
Firmware: DD-WRT v24-sp2 (12/22/14) std

My 0x00000.bin is ca 27kbyte
My 0x40000.bin is ca 190kbyte

I have three diffrent routers/AP. ESP8266 can connect to the two other (D-link and Cisco).
In DD-WRT i tried lot of diffrent settings, AES+TKIP, AES, TKIP and G, N, GN modes
I tried to use WPA instead of WPA2.

Nothing worked. I always get "STATION_CONNECTING (1)" followed by "STATION_WRONG_PASSWORD (2)"
The password is correct, I am sure.

I'am running wifi_station_get_connect_status() every 500ms. And I usually only get one STATION_WRONG_PASSWORD (2)
before it returns to reporting 1 as in connecting again. With some settings on router i get 2 continously.

The only time I successfully got the ESP to connect to the TPLink was when I disabled authentication completly at the router.

Any ideas?

Best regards
Mikael

Statistics: Posted by adent — Mon Apr 18, 2016 8:00 am

]]>