In an attempt to load esp-link (transparent bridge) onto a ESP-07 variant (8MB Quad) I am stuck in trying to restore the original binaries (the notes suggest this should be esp_iot_sdk_v1.2.0_15_07_03 but this does not work)
Can someone provide the correct binaries for this module (query status shown below) and indicate to which flash addresses they should be installed.
Should esp-link work on this module? (if so please indicate the correct binaries and addresses).
flash vendor:
E0h : N/A
flash devID:
4014h
QUAD;8Mbit
crystal:
26 Mhz
Connecting...
chip sync ok!
0x3ff00050: 04880000
0x3ff00054: 02008c03
0x3ff00058: 6400b000
0x3ff0005c: 005ccf7f
EFUSE MODE : 1
reg0:04880000
reg1:02008c03
reg2:6400b000
reg3:005ccf7f
check_err_0: 0b
check_err_1: 00
check_err_2: 00
check_err_3: 02
check_err_4: 0b
====================
EFUSE NORMAL MODE
====================
=========================
CRC IN MODE 1:
crc_calc_res: 100
target crc val: 100
=========================
=========================
CRC IN MODE 1:
crc_calc_res: 136
target crc val: 136
=========================
==================
EFUSE LOG:
======================
EFUSE LOG:
---------------
REG0:04880000
REG1:02008C03
REG2:6400b000
REG3:005CCF7F
----------------
====================
EFUSE NORMAL MODE
====================
EFUSE CHECK PASS...
=================
reg2>>13: 5
=================
48bit mac
debug:
-----------------------
5c cf 7f 8c 03 04
ID FOR XM: 06 40 00 00 00 08 80 00
XM_ID: 0640000000088000
-----------------------
crc_efuse_4bit: 0
crc_calc_4bit: 0
48bit mac
MAC AP : 5E-CF-7F-8C-03-04
MAC STA: 5C-CF-7F-8C-03-04
get mac res: True
('tttest uuuuuuuuuuart : uart reg: ', 4
(' baudrate: ', 115200)
get crystal: 26553600
head: 0 ;total: 0
erase size : 0
get flash id : 0xff1440e0
manufacturer_id: 0xe0
device_id: 0x4014
vendor: 224
mode: 64
size: 20
com closed
Thanks & Regards
ActiveStatistics: Posted by Active — Mon Apr 25, 2016 1:16 am
]]>