ESP8266 Developer Zone The Official ESP8266 Forum 2016-05-13T17:10:50+08:00 https://bbs.espressif.com:443/feed.php?f=7&t=2163 2016-05-13T17:10:50+08:00 2016-05-13T17:10:50+08:00 https://bbs.espressif.com:443/viewtopic.php?t=2163&p=6886#p6886 <![CDATA[Re: AT Command Software Locations?]]>
It is a UART tool, in fact, you can use any UART tool, for example, SecureCRTPortable.

Thanks for your interest in ESP8266 !

Statistics: Posted by ESP_Faye — Fri May 13, 2016 5:10 pm

]]> 2016-05-12T16:22:43+08:00 2016-05-12T16:22:43+08:00 https://bbs.espressif.com:443/viewtopic.php?t=2163&p=6857#p6857 <![CDATA[AT Command Software Locations?]]>
Here I am studying about 2d-esp8266_at_programming_guide_en_v1.3.pdf

I used to use putty as an software tool for setting the setup of the baud rate / serial port console .......

But in fact, I do not know what the software is as shown below and where I can download
(This picture was captured from the pdf files)
tools_downloads.png

Statistics: Posted by PaulTsai111 — Thu May 12, 2016 4:22 pm

]]>