Search found 5 matches

by Joe WeatherBalloon
Thu Dec 07, 2017 9:03 am
Forum: AT+ Commands
Topic: question about "AT+RFPOWER" command
Replies: 1
Views: 8893

Re: question about "AT+RFPOWER" command

Greetings! I have seen the same behavior as Alessandro. I would also like to know if the new RXPOWER is saved. I have the Esp8266_at_instruction_set_en_v1.5.4_0.pdf instruction set. Based on the pattern of how the commands are documented, I'm guessing the value is not saved. Can someone confirm, ple...
by Joe WeatherBalloon
Tue Jul 11, 2017 9:12 am
Forum: General Q&A
Topic: Flash Download Tool 3.4.9 does not start on Windows
Replies: 3
Views: 1392

Re: Flash Download Tool 3.4.9 does not start on Windows

UPDATE ON THIS QUESTION The command AT+UART_CUR? responds with ERROR (ver 1.1.0.0). This left me with the impression that AT+UART_CUR was not a part of the AT command set in that version. My mistake. When I use this command AT+UART_CUR=9600,8,1,0,0 the baud rate was changed and remained so while the...
by Joe WeatherBalloon
Tue Jul 11, 2017 7:59 am
Forum: General Q&A
Topic: Flash Download Tool 3.4.9 does not start on Windows
Replies: 3
Views: 1392

Flash Download Tool 3.4.9 does not start on Windows

Greetings! I want to update the AT version on my ESP01 from 1.1.0.0 to 2.1.0 so I can change the baud rate of the board. I downloaded the Flash Download Tool, 3.4.9, and attempted to start it. Having used a previous version, I was looking for the UI to appear. Instead, the console displays a lot of ...
by Joe WeatherBalloon
Sat Jun 17, 2017 3:17 am
Forum: General Q&A
Topic: Baud Rate Change Attempt Bricks ESP-01
Replies: 2
Views: 1744

Re: Baud Rate Change Attempt Bricks ESP-01

By the way, did you try baud rate of 74880 to see what the ESP8266 is printing out? Hello Pratik! Thanks for the prompt reply! Unfortunately, I did connect Tx to Rx. The claim was it brought back two ESP-01s. It is, of course, one of my more boneheaded moves but nothing else corrected the issue. I ...
by Joe WeatherBalloon
Fri Jun 16, 2017 8:15 am
Forum: General Q&A
Topic: Baud Rate Change Attempt Bricks ESP-01
Replies: 2
Views: 1744

Baud Rate Change Attempt Bricks ESP-01

Greetings! I experimented with my ESP8266 ESP-01 through Termite and verified I was able to connect to my test device. After a second verification, I investigated methods to drive the ESP-01 through an Arduino Pro Mini. The Pro Mini has a single UART. Thinking I would need to monitor the ESP-01 comm...

Go to advanced search