While configuring ESP8266 in softAP mode i am using this AT command
AT+CWSAP=<ssid>, <pwd>, <chl>, <ecn>[, <max conn>][, <ssid hidden>]
where <ssid hidden> parameter is set to 1 (i.e do not broadcast SSID of ESP8266 soft-AP) .Response to this command is OK but still when i searched for available APs in my phone it shows SSID of configured ESP8266. All this happens on SDK Version:0.9.5(b1) firmware version.
Guide me to solve this issue.
i updated the module with this version AT version:0.50.0.0(Sep 18 2015 20:55:38) SDK version:1.4.0 and it worked fine, now the ssid is hidden. But the connection gets lost most of the time when sending data using AT+CIPSEND command it gives this msg
Recv 10 bytes
which is not acceptable in my application. Can u please send me a link for latest firmware, in which AT+CIPSEND command SEND FAIL issue is solved so that i can try with that
I upgrade my smart wifi module with the firmware given on this link //bbs.espressif.com/viewtopic.php?f=46&t=2451 as suggested by you, but when i restart this module it gives me garbage at all baud rates, not a single AT command works also the serial BLUE LED always remains ON. I updated firmware for 8Mbit flash for both BOOT and NON BOOT mode.
Can you tell me where m going wrong?
Who is online
Users browsing this forum: No registered users and 2 guests
Newbies Start Here
Are you new to ESP8266?
Unsure what to do?
Dunno where to start?
Start right here!
We also have a RTOS version and a MESH version too!
Complete listing of the official ESP8266 related documentation release by ESPRESSIF!
Must read here!