question about "AT+RFPOWER" command

[Alessandro Cortese]

Hi!

i have a question about the following at command: AT+RFPOWER=<tx_power_level>.
i have seen that the command works changing tx power level because the radio replies with a "OK".
but...what happens if i turn off the power supply and i reconnect it again? can the module maintain that value or not?

Thanks,

Alessandro

[Joe WeatherBalloon]

Greetings!

I have seen the same behavior as Alessandro. I would also like to know if the new RXPOWER is saved. I have the Esp8266_at_instruction_set_en_v1.5.4_0.pdf instruction set. Based on the pattern of how the commands are documented, I'm guessing the value is not saved. Can someone confirm, please?

Thanks!
Joe