I have a ESP8266EX_Demo board.
I downloaded binaries in ESP8266_NONOS_SDK_V2.0.0 to the board to use AT commands.
And I can see some message when the connection is occurred, but I can’t see any response from the board when I sent AT command using PC.
Please see below steps(images) and let me know what is wrong or missing.
Demo board image
PC terminal App. setting.
I can see some of message when connection is occured.
Sending AT command. Write "AT" and press 'Enter' key. I can't see any response from demo board.
Thanks for your replay.
I think ‘add a new line’ same as pressing ‘Enter’ key in the application.
The last image shown the final situation when write “AT” + press ‘Enter’ in PC.
The cursor moves first column after pressing 'Enter' key, same as in case of "AT+GMR".
If you know other method to add a new line with PC or the other PC application to send AT command, please let me know. (My OS is Windows7)
Who is online
Users browsing this forum: No registered users and 8 guests
Newbies Start Here
Are you new to ESP8266?
Unsure what to do?
Dunno where to start?
Start right here!
We also have a RTOS version and a MESH version too!
Complete listing of the official ESP8266 related documentation release by ESPRESSIF!
Must read here!