Postby travjav » Sat Oct 19, 2019 12:21 am
I need some help determining why ESP-WROOM-02D does not respond back to me other than when i boot it up and click the reset button; in which case I receive a "ready".
I have two different modules of these and they both respond the same way on different computers using different apps ( I used the Arduino serial ) and another application for Linux and always get the same result, which is no response. I have tried different variations i.e new line and return with no luck. I also am using the correct baud rate specified by the manufacturer which is 115200 along with other baud rates higher or lower but am unable to get anything. I also have tried hooking this up to my ARM device and sending AT commands with no luck, i'm really unsure how to proceed at this point and is becoming the main blocker in my project and we're dependent on the success of it's connectivity. Any help is appreciated, thank you.
Postby travjav » Sun Oct 27, 2019 11:18 am
Who is online
Users browsing this forum: No registered users and 3 guests
Newbies Start Here
Are you new to ESP8266?
Unsure what to do?
Dunno where to start?
Start right here!
We also have a RTOS version and a MESH version too!
Complete listing of the official ESP8266 related documentation release by ESPRESSIF!
Must read here!