I am working on ESP8266.
Firmware version AI-v0.9.5.0 AT Firmware.bin.
when I started with this I was able to post my data on thingspeak.com, but now I am not able to post my data.
I am following below sequence for posting my data
please note that i am adding \r\n after every command and my esp is already connected to the internet.
sent -: AT+CIPMUX=1\r\n
Received -: \r\n OK \r\n
sent -: AT+CIPSTART=4,"TCP","www.thingspeak.com",80\r\n
Received -: 4,CONNECT\r\n
sent -: AT+CIPSEND=4,43
Received -: >
sent -: GET /update?key=IFHKMTNS05DJUFID&field1=60\r\n
I am expecting +IPD after successful posting to the thingspeak but not getiing that only SEND OK is received.
in CIPSEND command if I give a number of characters to be sent is 44, then esp is waiting and stuck there not giving any response and if I give 43 its giving SEND OK, I have tried by adding \r\n\r\n after GET request but I am not able to post data.
By using the same sequence I was able to use send data but now it's not working.
please help me!!!
any help will be highly appreciable.
Postby pratik » Thu Jul 06, 2017 12:47 pm
Please find the latest firmware from here:
https://github.com/espressif/ESP8266_NO ... master/bin
Also, I think you are sending the GET request incorrectly. That's why your connection is being "CLOSED" right after the request. Try to send GET request using telnet on Windows to verify that you are doing it right....then do it on ESP8266.
Who is online
Users browsing this forum: No registered users and 3 guests
Newbies Start Here
Are you new to ESP8266?
Unsure what to do?
Dunno where to start?
Start right here!
We also have a RTOS version and a MESH version too!
Complete listing of the official ESP8266 related documentation release by ESPRESSIF!
Must read here!