Postby sschoedel » Sat Feb 22, 2020 6:35 am
I have been working with an ESP-12E for the past few days and have encountered a few problems. I've fixed a few of them, but I haven't been able to figure out how to set the cipmode in flash. I don't want the ESP to be in passthrough mode, but every time I restart it, CIPMODE is always 1. I've been able to use AT+SAVETRANSLINK to change CIPMODE in the past, but now whenever I enter the SAVETRANSLINK command it just says error.
I'm connecting to the ESP through a teensy 4.0. Please let me know if there is a way, and how, I can permanently set the cipmode value to 0. Thank you!
Who is online
Users browsing this forum: No registered users and 2 guests
Newbies Start Here
Are you new to ESP8266?
Unsure what to do?
Dunno where to start?
Start right here!
We also have a RTOS version and a MESH version too!
Complete listing of the official ESP8266 related documentation release by ESPRESSIF!
Must read here!