TCP server Passthrough mode

[mvandere]

The manual implies that a single session TCP server can go into a UART-WIFI passthrough mode.

I can't seem to find the right combination of commands to make this happen.

Can you show me the commands necessary to set this up, with comments where needed?

Thanks,

Mark

[ESP_Faye]

Hi，

Sorry that if ESP8266 works as TCP server，passthrough mode can not be enabled.

Only ESP8266 works as TCP client , or UDP transmission, in single connection mode, can enable passthrough mode.

Sorry for the inconvenience.

[skatjus]

Hello,
Did you find the answer about transparant mode ?
I try to send unknow amout of byte but it only work in client mode not in server mode...
We like very much to have TCP server Passthrough mode.
I try to use the 8266-01. Thanks if you have an answer.