I designed a custom PCB for a ESP-12 module. However I think I am facing some PSU issues.
the PSU is 5V and The PCB has a LF33 (and external components)
After booting, the ESP states: "ready" then "Wifi disconnect"
The point is, If I add capacitors to the 3.3V lane, the behaviour is more stable. But it varies between each ESP-12 module. And also what I noticed: This unstable behaviour is only observed when using the AT firmware.
I was able to reporduce the behaviour using a Wemos D1 Mini board. It works stable, using the delivered firmware, however when flashing the latest AT firmware to the device, it behaves unstable (increasing ping times, sometimes no connection) - When adding a capacitor to the 3.3V of the wemos board, it is stable again.
Is the AT firmware transient load higher? If yes, why? and is there a configuration parameter, that I can decrease peak power consumption?
Also, is the ESP32 more stable than that? Are there any modules that include a 5V to 3.3V line converter that handles the AT firmware?
Who is online
Users browsing this forum: No registered users and 4 guests
Newbies Start Here
Are you new to ESP8266?
Unsure what to do?
Dunno where to start?
Start right here!
We also have a RTOS version and a MESH version too!
Complete listing of the official ESP8266 related documentation release by ESPRESSIF!
Must read here!