I have some experience with ESP-01 and ESP-03 modules.
I have written some C code on it, using the Arduino adaptation layer.
With this code, I got an application that uses the HSPI port of the ESP8266EX to connect to a SPI accelerometer (ADXL362).
My problem is that the same application does not work at all on the ESP_LAUNCHER board.
I see on scope that SCK signal and CS signals are moving as expected, but MISO and MOSI remain steady.
Any help would be appreciated.
Shematic and PCB layout of ESP-LAUCHER can be obtained in below link.
If you want to use HSPI interface, please try to remove C8(besides reset key) and R58(besides IR-emitter diode) first.
More questions, please let us know.
Who is online
Users browsing this forum: No registered users and 2 guests
Newbies Start Here
Are you new to ESP8266?
Unsure what to do?
Dunno where to start?
Start right here!
We also have a RTOS version and a MESH version too!
Complete listing of the official ESP8266 related documentation release by ESPRESSIF!
Must read here!