Arduino IDE, you need the Arduino ESPNOW extension. Firmware is "espnow_6050".
Esp8266, mpu6050, four 0xF5 esc with 128kbaud. Flies like a wet sponge. You have been warned.
The attached firmware is just for illustration, not finished in any way, but i have flown it sucessfully.
It needs a special "serial esc" firmware. Konze 0xF5 protocol. See here:
It should be possible to use normal ESC instead of serial by using analogwrite().
ACC needs to be calibrated by entering "A" in the serial console. Copter must be level during calibration. Values are stored.
The transmitter is a simple PPM (ppmsum) to EspNOW converter. Transmitter firmware is "espnow_rc".
More info (but outdated firmware) here
Very useful as for me.
I`m also using quadcopter.
Nice to know now i`m able to use in future "EspNowCopte the ESP8266"
Thanks again for your responses.
Postby SEGOHOKSINFIG » Fri Sep 27, 2019 1:51 pm
Who is online
Users browsing this forum: No registered users and 2 guests
Newbies Start Here
Are you new to ESP8266?
Unsure what to do?
Dunno where to start?
Start right here!
We also have a RTOS version and a MESH version too!
Complete listing of the official ESP8266 related documentation release by ESPRESSIF!
Must read here!