I am not sure if where the proper place to is to post this so please redirect me if you know. Thank you!
I have been working on creating my own module based off the hardware schematics of the ESP8266EX. I am flashing it using the Arduino IDE. I am able to write to the flash memory but am unable to read from it. I get the following error.
ets Jan 8 2013,rst cause:2, boot mode:(3,7)
load 0x4010f000, len 1384, room 16
I know I am able to write to the memory because after doing so, I remote the flash memory from my DIY module and solder it onto the ESP-01 module and find that it is running my code. I am not sure why my current module is unable to read from the memory. I have been working on this for over a week and have no other ideas on what to try. Any suggestions would be appreciated!
Who is online
Users browsing this forum: No registered users and 1 guest
Newbies Start Here
Are you new to ESP8266?
Unsure what to do?
Dunno where to start?
Start right here!
We also have a RTOS version and a MESH version too!
Complete listing of the official ESP8266 related documentation release by ESPRESSIF!
Must read here!