80211-s mesh support for ESP8266

Ravikumar

80211-s mesh support for ESP8266

Postby Ravikumar » Thu May 05, 2016 5:53 pm

Hi,

I have connected esp-12e module to raspberry pi(with SDIO) and installed esp8086 driver. i got wan0 interface and able to connect AP.

Now i want check 80211s mesh with esp.

i've tried following command and got error.
pi@raspberrypi:~/esp8089 $ sudo iw dev wlan0 interface add mesh0 type mp mesh_id mymesh
command failed: Operation not supported (-95)



Is esp8086/8266 linux driver supporting mesh capabilities?

ESP_Alen

Re: 80211-s mesh support for ESP8266

Postby ESP_Alen » Thu May 12, 2016 7:28 pm

Ravikumar wrote:Hi,

I have connected esp-12e module to raspberry pi(with SDIO) and installed esp8086 driver. i got wan0 interface and able to connect AP.

Now i want check 80211s mesh with esp.

i've tried following command and got error.
pi@raspberrypi:~/esp8089 $ sudo iw dev wlan0 interface add mesh0 type mp mesh_id mymesh
command failed: Operation not supported (-95)



Is esp8086/8266 linux driver supporting mesh capabilities?


Sorry, ESP-Mesh is not 80211s.
It is designed and implemented by ESPRESSIF.

DavidSchott
Posts: 1
Joined: Tue Nov 27, 2018 8:31 pm
Location: https://writemyessaytoday.net/

Re: 80211-s mesh support for ESP8266

Postby DavidSchott » Tue Nov 27, 2018 8:47 pm

I have the wpad-mesh installed, which I guess is enough to support 802.11s secure mesh.
I have tried the same configuration and secure mesh works with wpad-mesh and it is all on a TP-Link Archer C7. The only difference is the wireless driver: ath10k on the TP-Link, mt76 on the ZBT.

micuki
Posts: 1
Joined: Fri Mar 10, 2017 3:17 am

Re: 80211-s mesh support for ESP8266

Postby micuki » Mon Apr 08, 2019 10:48 pm

I have used a logical analyzer to monitor the RTS signal, and the voltage level of RTS pin was always low, I think the hardware flow control of ESP8266 can not work, maybe there are some bugs on the firmware.

porno svensk porrfilmer phim sex porno gratis

Who is online

Users browsing this forum: No registered users and 2 guests