I'd like to program the AT firmware on an ESP8285 (custom board).
I've found my way through programming but I got an error at startup.
See attached pictures of programming screen and error.
Could you explain to me what I'm doing wrong ?
Bonus question : is there a way to start with 115200 baudrate instead of 74880 ?
I spotted your problem while fighting with AT firmware on ESP8285 himself. I hope the community will forgive me for resurrecting the old thread.
Your setup is correct but maybe you are trying to flash a very old firmware (1.5.1), I flashed 2.1.0.
I used an old flash tool and it worked! On the contrary I had problems with newer flash tools.
Maybe it can help someone.
Who is online
Users browsing this forum: No registered users and 3 guests
Newbies Start Here
Are you new to ESP8266?
Unsure what to do?
Dunno where to start?
Start right here!
We also have a RTOS version and a MESH version too!
Complete listing of the official ESP8266 related documentation release by ESPRESSIF!
Must read here!