I have one of these devices:
and on powering up it creates a WiFi AP without being told to do so (the Arduino sketch does nothing).
I'm guessing that it has some firmware installed on the ESP8266 which is not the standard AT command firmware.
Can this be confirmed?
If it is the case, how do I update the ESP2866 to the correct AT Command firmware?
Who is online
Users browsing this forum: No registered users and 4 guests
Newbies Start Here
Are you new to ESP8266?
Unsure what to do?
Dunno where to start?
Start right here!
We also have a RTOS version and a MESH version too!
Complete listing of the official ESP8266 related documentation release by ESPRESSIF!
Must read here!