I have a problem with the Huzzah not waking up from Deep Sleep.
GPIO16 is jumpered to the Reset pin, both GPIO0 and GPIO2 has 10k pullup resistors to V3.3.
If I reset it with the reset button I get the following response:
ets Jan 8 2013,rst cause:2, boot mode:(3,6)
load 0x4010f000, len 1384, room 16
and then the code runs normal.
When it wakes up from deep sleep I get the following response:
ets Jan 8 2013,rst cause:5, boot mode:(3,6)
and the red led comes on. It will then stay indefinitely in that mode.
Any help will be appreciated
if your log information show "ets_main.c",your code is all rigth,maybe your moudle GPIO16 is disconnect your RST.you can refer to our sample code.GPIO16 must connect RST,because of when the deep time is comming,GPIO16 trigger a low level.
Who is online
Users browsing this forum: No registered users and 3 guests
Newbies Start Here
Are you new to ESP8266?
Unsure what to do?
Dunno where to start?
Start right here!
We also have a RTOS version and a MESH version too!
Complete listing of the official ESP8266 related documentation release by ESPRESSIF!
Must read here!