that's true, but not the answer to the question. The nominal range is well documented in the datasheet and i know them. The maximum values are not documented.
What are the maximum values you can apply without destroying the chip?
In my project it might be that there are about 2.5V. I will add two diodes for clipping this voltage. The result is 1.4 V. Naturally this will give no valid reading, but does it destroy the chip? What about -0.3V using a Schottky diode for clipping negative voltages?
Who is online
Users browsing this forum: No registered users and 2 guests
Newbies Start Here
Are you new to ESP8266?
Unsure what to do?
Dunno where to start?
Start right here!
We also have a RTOS version and a MESH version too!
Complete listing of the official ESP8266 related documentation release by ESPRESSIF!
Must read here!