1. 3V3 connected to serial board 3.3V
2. GND connected to serial board GND
3. TX to serial board RX
4. RX to serial board TX
5. EN pin is 3.3V
Only when RST button is pressed is the following result received on the monitor (74880baud):
ets Jan 8 2013,rst
cause:2, boot mode:(3,6)
load 0x4010f000, len 1384, room 16
No response to AT commands.
What can be the issue?
Postby pratik » Sat Sep 30, 2017 11:23 pm
Also, please use a 3.3V USB-UART converter. 5V can damage the ESP8266!
Who is online
Users browsing this forum: No registered users and 2 guests
Newbies Start Here
Are you new to ESP8266?
Unsure what to do?
Dunno where to start?
Start right here!
We also have a RTOS version and a MESH version too!
Complete listing of the official ESP8266 related documentation release by ESPRESSIF!
Must read here!