The first point is that the serial protocol specification mentions four 32 bit words but lists five input parameters: https://github.com/espressif/esptool/wi ... 266--esp32
My second doubt is that I don't quite get what these parameters should look like, there's a bare description of the parameter names in this other section: https://github.com/espressif/esptool/wi ... ding-flash
If I understand correctly there's no other command required to start receiving the flash data payload, I'm also assuming that an initial sync is required (SYNC). This is something I'm already doing for READ_REG.
I would appreciate if anyone could help me understand the READ_FLASH parameters as well as provide some sample input.
Who is online
Users browsing this forum: No registered users and 3 guests
Newbies Start Here
Are you new to ESP8266?
Unsure what to do?
Dunno where to start?
Start right here!
We also have a RTOS version and a MESH version too!
Complete listing of the official ESP8266 related documentation release by ESPRESSIF!
Must read here!