ets Jan 8 2013,rst cause:1, boot mode:(3,6)
load 0x40100000, len 1856, room 16
load 0x3ffe8000, len 776, room 8
load 0x3ffe8310, len 552, room 8
2nd boot version : 1.5
SPI Speed : 40MHz
SPI Mode : DIO
SPI Flash Size & Map: 8Mbit(512KB+512KB)
jump to run user1 @ 1000
rf cal sector: 249
rf : 00
rf : 00
rf : 01
SDK ver: 184.108.40.206(39cb9a32) compiled @ Jul 1 2016 20:04:35
phy ver: 972, pp ver: 10.1
but when I run the ESP8266 download tool, the DETECTED INFO block shows:
A1h : FM
So which should I believe when programming the device?
Should I use DIO or QIO?
Should I use 8Mbit, or 32Mbit?
What addresses should I use for default.bin, blank.bin, user1 bin, and user2 bin?
8Mbit(512KB+512KB) is the flash map you selected on the ESP Flash Download Tool when downloading.
QUAD;32Mbit is the actual size of your flash.
So it means that you are using a 32Mbit flash as a 8Mbit flash.
You can select 32Mbit on the ESP Flash Download Tool when downloading to make full use of it.
Who is online
Users browsing this forum: No registered users and 1 guest
Newbies Start Here
Are you new to ESP8266?
Unsure what to do?
Dunno where to start?
Start right here!
We also have a RTOS version and a MESH version too!
Complete listing of the official ESP8266 related documentation release by ESPRESSIF!
Must read here!