crystalfreq to 26M
SPI speed to 40MHz
Flash size to 8Mbit
proper com port
baudrate to 115200
After i set ESP to flash mode i hit START. All gone ok with last lines on terminal:
writing at 0x000fc000... (99%)
And on download tool i get massage Finish. I pressed reset on my ESP and after that i started Serial to check the result. But there is nothing.
When i disconnect CH_PD for a sec i get: ets Jan 8 2013,rst cause: 1, boot mode:(1,7) which i think indicates not enough power.
I power ESP with external power supply on 9V 600mA step down with XL4015 to 3,3V which i checked with multimeter.
No it doesn't work or i didn't do something right. Any help would be nice.
Who is online
Users browsing this forum: No registered users and 7 guests
Newbies Start Here
Are you new to ESP8266?
Unsure what to do?
Dunno where to start?
Start right here!
We also have a RTOS version and a MESH version too!
Complete listing of the official ESP8266 related documentation release by ESPRESSIF!
Must read here!