External UART connect to RX and TX during flashing

Post Reply
AgentSmithers
Posts: 195
Joined: Sat Apr 01, 2017 1:21 am
Contact:
Contact AgentSmithers

External UART connect to RX and TX during flashing

Postby AgentSmithers » Thu Jun 14, 2018 11:20 pm

Everyone,
I have a FTDI connected to my RX and TX on my ESP Wemos D1 Mini Pro. I have to physically disconnect the RX Pin on my Wemos D1 to flash new firmware. My Guess is that pin is shared with the USB interface built onto the Wemos board so my two options are to keep physically disconnecting the RX pin or do a UART swap so different pins are used for the UART during runtime correct?
Are there any other options?
Thanks!
-Nicholas
Top
Post Reply

Return to “ESP8266 SDK”



Who is online

Users browsing this forum: No registered users and 138 guests