Page 4 of 9

Re: New FEATURES gathering

Posted: Mon Jan 26, 2015 9:00 pm
by alexAria
Low level access to PHY MAC ,
being able to send and receive 802.11 packets.

Re: New FEATURES gathering

Posted: Thu Feb 05, 2015 7:22 pm
by costaud
;) ;) ;)

Re: New FEATURES gathering

Posted: Sun Feb 08, 2015 3:17 pm
by arkhantum
Hi Costaud,
In IOT SDK, perhaps there are some methods that allow user to update the needed key from an apps(for example esp8266 android related apps).the apps will request the key from server separately, later when the apps already got the key, we can easily write this key to that specific address of the esp device.
Thank you

Re: New FEATURES gathering

Posted: Fri Feb 13, 2015 6:25 pm
by SL!M
Hello, I think a very important feature is to be able to define your own update server, it would make our lives lot easier :D

Re: New FEATURES gathering

Posted: Mon Feb 16, 2015 9:24 am
by tve
Support the FreeRTOS SDK, it's so much better than the std SDK!

Re: New FEATURES gathering

Posted: Sun Apr 05, 2015 12:24 am
by SL!M
The new AT commands v0.23 seems to be stable enough, but we still need SSL connection AT command.
Custom upgrade command was a great addition :D I didn't try it yet...
Thanks!

Re: New FEATURES gathering

Posted: Mon Apr 06, 2015 8:10 pm
by israellot
Support for packet injection on 802.11 :)

Re: New FEATURES gathering

Posted: Fri Apr 10, 2015 1:31 am
by cortinas
Publish source for all the blobs --- or at least the wifi / 80211 ones so at least we can figure out what is going on

Re: New FEATURES gathering

Posted: Fri Apr 10, 2015 1:32 am
by mculibrk
costaud wrote:How about Uart and SPI port, what kind of interrupt event do you want ??


It would be very nice to have some sort of "threshold" for generating the SPI (or other UART...) interrupts.

Interrupts are now triggered only on completion of some action - for example int on end transfer.

What I mean is to have some way of configuring the interrupt to trigger before the entire fifo/buffer is processed.

Why? If you need to have a "constant" output stream (on SPI or UART) you should start filling (or reading) the fifo before the end of transmission/reception otherwise there will always be gaps - after the interrupt triggers you need time to re-fill the fifo and start a new transfer.


regards

Re: New FEATURES gathering

Posted: Fri Apr 10, 2015 1:39 am
by mculibrk
DMA engine with few channels, triggers linked to wifi/uart/spi/i2s... peripherals (to be able to configure a simple "data pump" from wifi to spi or i2s etc)