Is it possible to use WPS when ESP8266 is in AP+STA Mode? I would like that the device tries to check for a WPS router (config) while maintaining a web server (user interface) available. That way the user of the final device could use WPS if available (on his router) but could also connect to the final device directly (AP) and configure it via web interface.
Looking forward to hearing from you soon,
The idea is:
If the network connection has not been setup yet - the device will start in AP+STA with a web user interface, so that the end user can connect to the device network (AP) and configure it. However if the end user has a router at home with WPS, it would be very good I we could at the same time enable the WPS config automatically for about 1 minute (after power on). That way the user would be able to try WPS connection (simple) but if not available (or unable) could still connect to the device network (AP) and setup manually. After network setup (Web UI or WPS) the device will only use STA mode (connected to the home router).
Who is online
Users browsing this forum: No registered users and 20 guests
Newbies Start Here
Are you new to ESP8266?
Unsure what to do?
Dunno where to start?
Start right here!
We also have a RTOS version and a MESH version too!
Complete listing of the official ESP8266 related documentation release by ESPRESSIF!
Must read here!