1. The SSID of the node's networks is HIDDEN and not broadcasted. The nodes DON'T show up at all by default. It also seems to be impossible to change this behaviour with the code available from the mesh-SDK since any change done to the access-Point-configuration beforehand is overwritten by mesh_enable().
2. From my experience, it is not possible to connect to a mesh-node's sub-network from a non-mesh device like a mobile, etc.
3. Other than low power leafe-nodes, it is not possible to operate a mesh-node in station-mode only (since then no further ESP could connect to the node and no mesh could be spanned).
Who is online
Users browsing this forum: No registered users and 23 guests
Newbies Start Here
Are you new to ESP8266?
Unsure what to do?
Dunno where to start?
Start right here!
We also have a RTOS version and a MESH version too!
Complete listing of the official ESP8266 related documentation release by ESPRESSIF!
Must read here!