i am trying to use UART1 for debugging.
This is what i have done so far:
- Connected FTDI RX pin to ESP8266 GPIO2
I did point uart1_write_char to the same function in your uart.c file.
Is this correct? Or should i implement it by myself?
My problem is that there is no data at all received by my terminal program in Ubuntu.
What am i doing wrong?
Who is online
Users browsing this forum: No registered users and 11 guests
Newbies Start Here
Are you new to ESP8266?
Unsure what to do?
Dunno where to start?
Start right here!
We also have a RTOS version and a MESH version too!
Complete listing of the official ESP8266 related documentation release by ESPRESSIF!
Must read here!