I flashed my ESP-01 with ESP Flash download tool V2.3. SDK i used is ESP8266_NONOS_SDK_V.2.0.0_16_08_10 downloaded from here. I added this paths:
blank.bin 0xFB000
esp_init_data_default.bin 0xFC000
blank.bin 0x7E000
blank.bin 0x7E000
boot_v1.6.bin 0x00000
at\...\user1.1024.new.2.bin 0x01000
I set:
crystalfreq to 26M
SPI speed to 40MHz
Flash size to 8Mbit
proper com port
baudrate to 115200
After i set ESP to flash mode i hit START. All gone ok with last lines on terminal:
writing at 0x000fc000... (99%)
leaving...
com closed
And on download tool i get massage Finish. I pressed reset on my ESP and after that i started Serial to check the result. But there is nothing.
When i disconnect CH_PD for a sec i get: ets Jan 8 2013,rst cause: 1, boot mode:(1,7) which i think indicates not enough power.
I power ESP with external power supply on 9V 600mA step down with XL4015 to 3,3V which i checked with multimeter.
No it doesn't work or i didn't do something right. Any help would be nice.
No AT commands after flashing
-
- Posts: 3
- Joined: Wed Jan 17, 2018 4:16 am
Who is online
Users browsing this forum: No registered users and 118 guests
Login
Newbies Start Here
Are you new to ESP8266?
Unsure what to do?
Dunno where to start?
Start right here!
Latest SDK
Documentation
Complete listing of the official ESP8266 related documentation release by ESPRESSIF!
Must read here!
- All times are UTC+08:00
- Top
- Delete all board cookies
About Us
Espressif Systems is a fabless semiconductor company providing cutting-edge low power WiFi SoCs and wireless solutions for wireless communications and Internet of Things applications. We are the manufacturer of ESP8266EX.