I am using ESP8266 Download Tool V3.6.22 to download "ESP_FCC_V2.0_26M_20160401.bin on ESP-12F (EMC/RF performance).
It connects and show the detected informations until this point is ok, then I fill download path config and set 0x000 address.
Then I press the Start and immediately the panel 1 shows "STOP".
The error is reported in prompt log:
"UnicodeEncodeError: 'gbk' codec can't encode character u' \xe7' in position 26: ilegal multibyte sequence"
Please, could anybody help me?
Nerd and Embedded Design Consultant
Who is online
Users browsing this forum: No registered users and 0 guests
Newbies Start Here
Are you new to ESP8266?
Unsure what to do?
Dunno where to start?
Start right here!
We also have a RTOS version and a MESH version too!
Complete listing of the official ESP8266 related documentation release by ESPRESSIF!
Must read here!