I wander what does "user should enable the output" mean? Does it mean that the user should keep in mind that output should be enabled first, or does it mean that the user must set the corresponding bit in GPIO_ENABLE register simultaneously every time when writing to GPIO_OUT_W1TC, otherwise the value in GPIO_OUT_W1TC won't have effect on register GPIO_OUT or whatever?
I think we're not supposed to set registers directly at all, so I guess you won't get an answer to that.
Who is online
Users browsing this forum: Baltpamp and 0 guests
Newbies Start Here
Are you new to ESP8266?
Unsure what to do?
Dunno where to start?
Start right here!
We also have a RTOS version and a MESH version too!
Complete listing of the official ESP8266 related documentation release by ESPRESSIF!
Must read here!