I have a RobotDyn combined Arduino and ESP8266 board:
I have uploaded a sketch to the Arduino which does nothing - it sends no AT commands at all to the ESP.
Upon powering up, the ESP chip is creating a WiFi AP which I can connect to from my phone and laptop.
Does the normal AT Command software in the ESP do this itself, or is this chip running a special sketch?
RobotDyn themselves don't seem to know ;-(
Who is online
Users browsing this forum: TRAVELrep and 0 guests
Newbies Start Here
Are you new to ESP8266?
Unsure what to do?
Dunno where to start?
Start right here!
We also have a RTOS version and a MESH version too!
Complete listing of the official ESP8266 related documentation release by ESPRESSIF!
Must read here!