Do you plan to make an ethernet module very similar to Wroom02 with similar AT command set? It would be very nice.
We have looked at some other solutions, but till now we did not found one that could:
1, Run TCP on one socket
2. Run UDP on another socket simultanously
3. Read the UDP header (source ip and port) - the modules we examined only respons to the last client that it received a request from.
The last step is very important, if you have multiple simultaneosly clients connecting, or you will mix up the responses.
Who is online
Users browsing this forum: No registered users and 1 guest
Newbies Start Here
Are you new to ESP8266?
Unsure what to do?
Dunno where to start?
Start right here!
We also have a RTOS version and a MESH version too!
Complete listing of the official ESP8266 related documentation release by ESPRESSIF!
Must read here!