I'm using the ESP8266_NONOS_SDK_v2.0.0_16_08_10 and it's working well. The IoT_Demo example is also working fine. I registered an account at iot.espressif.cn, created a device and my ESP pings the server and gets the response. Until here, everytihng is ok.
After things are all right, I tried to update over the air. Reading the doccument "ESP8266 FOTA Introduction", Version 1.6, Friday, April 22, 2016, at page 10 it says:
"(2) Click a product which need to update firmware, find “ROM Deploy” at the right side of webpage. For example, we click “dev-controller” at above picture, and find “ROM Deploy”."
I found “ROM Deploy” section in my IoTBucket page, but it goes on at page 11:
"(3) Click “+ Deploy” to upload a new version of firmware. Follow steps showing below. ROM version format as “v1.0.1t23701(a)” according to appendix."
And my problem is here. I've found the "ROM Deploy" section, but there is no button [+ Deploy] in my IoTBucket page.
Is there a problem with my account? Did I make something wrong?
Who is online
Users browsing this forum: No registered users and 0 guests
Newbies Start Here
Are you new to ESP8266?
Unsure what to do?
Dunno where to start?
Start right here!
We also have a RTOS version and a MESH version too!
Complete listing of the official ESP8266 related documentation release by ESPRESSIF!
Must read here!