How do you change AT+CIPMODE flash memory?

sschoedel
Posts: 1
Joined: Sat Feb 22, 2020 6:26 am

How do you change AT+CIPMODE flash memory?

Postby sschoedel » Sat Feb 22, 2020 6:35 am

Hello!

I have been working with an ESP-12E for the past few days and have encountered a few problems. I've fixed a few of them, but I haven't been able to figure out how to set the cipmode in flash. I don't want the ESP to be in passthrough mode, but every time I restart it, CIPMODE is always 1. I've been able to use AT+SAVETRANSLINK to change CIPMODE in the past, but now whenever I enter the SAVETRANSLINK command it just says error.

I'm connecting to the ESP through a teensy 4.0. Please let me know if there is a way, and how, I can permanently set the cipmode value to 0. Thank you!

Her Mary
Posts: 453
Joined: Mon Oct 27, 2014 11:09 am

Re: How do you change AT+CIPMODE flash memory?

Postby Her Mary » Fri Feb 28, 2020 10:39 am

How about AT+RESTORE to factory reset it?

Who is online

Users browsing this forum: No registered users and 3 guests