Currently, i am working on a project that i use an ESP8266EX (ESP-01 module) in it. I use the AT commands to configure my ESP module and want to use it in STA mod to send data to useres who are connected to it. That is why i write down a HTML code. Deal is; I want to insert the HTML code i have already written in the SPI flash of my ESP so that it uploads the page with my HTML code.
So, i wonder if i can write to or read from SPI flash of my ESP by only using AT commands rather than Arduino IDE.
Thank you all!
Who is online
Users browsing this forum: No registered users and 15 guests
Newbies Start Here
Are you new to ESP8266?
Unsure what to do?
Dunno where to start?
Start right here!
We also have a RTOS version and a MESH version too!
Complete listing of the official ESP8266 related documentation release by ESPRESSIF!
Must read here!