I'm using AT+CIPSTART to establish a TCP link and my error trapping picked up quite a few fails and on expanding my debugging I discovered I seemed to be getting quite a few DNS fails for no apparent reason (can typically take 10-15 seconds or so for this error to be reported).
As a workaround I tried the IP address instead of the domain name but this immediately returns with an IP ERROR message. Although I was already on fairly current firmware I upgraded to AT Bin V1.6.1 but the symptoms are identical as the slightly earlier firmware.
The problem is reproducible on several different Arduinos including those with an ESP-01 and those with a Wemos Arduino Mega with integral 8266 flashed with the above firmware.#
Any ideas on both the DNS issue and the fact that substituting the server name with a pre-resolved IP fails immediately with an IP ERROR message?
Who is online
Users browsing this forum: No registered users and 5 guests
Newbies Start Here
Are you new to ESP8266?
Unsure what to do?
Dunno where to start?
Start right here!
We also have a RTOS version and a MESH version too!
Complete listing of the official ESP8266 related documentation release by ESPRESSIF!
Must read here!