Will the ESP8266 AT Command Examples document be updated to include the messages introduced in 2.2.0?
messages when clients are connecting to the AP? (I can't find a way in the AT command user guide)
Ideally, this could be done with the AT+SYSMSG set of commands, perhaps implementing another flag other than bits 0-1.
This would be very important for backward compatibility, which is now broken for me, unless I find a way to disable them, and it should serve as a warning about implementing new messages that aren't optional to enable.
My original query was prompted by a whole lot of code falling on its face due to a change in the responses that are generated in V2.2.0. If you take the Arduino stance where you never inspect the messages coming from the module, and just power type commands at the module, 2.2.0 may actually work. But I am actually responding to what the module returns from my commands and the responses have changed, but the changes are not documented anywhere.
The alternatives are to laboriously inspect the SPI conversation, on an oscilloscope, to discover how the protocol works now and submit the findings here, asking for clarifications, and have the developers say "yes". Or I could let the developers save face and just ask for someone to document how the protocol works by way of updating an existing document. Nobody gets called out for messing up the protocol, nobody gets upset.
Who is online
Users browsing this forum: No registered users and 1 guest
Newbies Start Here
Are you new to ESP8266?
Unsure what to do?
Dunno where to start?
Start right here!
We also have a RTOS version and a MESH version too!
Complete listing of the official ESP8266 related documentation release by ESPRESSIF!
Must read here!